in

How To Build A Secret Passageway Lamp That Turns On With The Tilt Of A Book

This guy has come up with a DIY project that is so easy to do. It doesn’t take a whole lot to accomplish and takes very little time. Read below to see what he did!

How To Build A Secret Passageway Lamp That Turns On With The Tilt Of A Book
You should have the brass armature, electrical cord, a pull string, 2 screws, and a zip tie. You will need a small Phillips screw driver, a pencil, scissors, and a hardcover book.

How To Build A Secret Passageway Lamp That Turns On With The Tilt Of A Book
Select the right book.  The book should be roughly 9 inches tall, 6 to 7 inches deep and about an inch and a half thick (about 400 pages). The book must be a hardcover with a separated spine. This means when you fold back the covers, you should see daylight through the spine. Older, worn in books tend to work best.

How To Build A Secret Passageway Lamp That Turns On With The Tilt Of A Book
Find a spot for the Secret Passageway Switch. Determine where on your bookshelf you want your switch to be. Near an end is usually best for concealing the wires later. Keep in mind you will need to run an electrical cord down the back or off to the side. Mark the desired location with the pencil and remove the books.

Attach the electrical cord. Unscrew the switch cap, place switch on the brass armature, re-attach switch cap, zip tie off of the electrical cord, and cut off excess zip tie.

Cutting the string to size. Measure the height of your book, with the armature open to 90 degrees, attach the end of the string to the pull chain, tie off the other end of the string to the armature, cut off excess string, un-attach the string from the pull chain. Note: it is a good idea to initially cut the string a little longer than you think you need, you can trim later.

How To Build A Secret Passageway Lamp That Turns On With The Tilt Of A Book
Mounting the armature. Using the pencil marks you made earlier, line up the armature in the desired spot. Screw the armature down. Hide the wire and plug it into the wall.

Attach the book to the switch. Feed the string and armature through the spine of the book. Open the book to the middle page, attach the string to the pull chain, close the book.

How To Build A Secret Passageway Lamp That Turns On With The Tilt Of A Book
Finishing up. Place other books back on the shelf next to the switch. Make sure it is not too tight and the book can move easily. Plug whatever you like into the switch’s plug and you’re done.

H/T

And there you have it. You now have a hidden passageway lamp without the mess of cords.

Leave a Reply

Your email address will not be published.

Loading…

0

What are your thoughts?